PUFFY PE 20 (soft) 3 mm black, 40x30 cm, 10 sheets, EVA foam
Product information "PUFFY PE 20 (soft) 3 mm black, 40x30 cm, 10
sheets, EVA
foam"
Truly Outstanding Embroidery Effects!
Material Composition: 90-94% polyethylene / 6-10% additives
Embroidering with PUFFY
Product description
Bulky, raised monograms, three-dimensional patterns – embroideries made with PUFFY will stun everyone! For creating the enhanced 3D effect. The embroidery design is simply satin-stitched over the foam, giving caps, promotion wear and outerwear a completely new touch.
Available in 2 densities:
PE 20: soft, highly suitable for outerwear
PE 10: harder, for caps and logos
PE 20: soft, highly suitable for outerwear
PE 10: harder, for caps and logos
Material Composition: 90-94% polyethylene / 6-10% additives
Download Area:
Downloads
PUFFY - Embroidery Foam for Three-Dimensional Effects
- Place PUFFY on the fabric to be embroidered and attach it with adhesive spray KK, if needed. u Satin-stitch your design. The machine needle perforates the foam during stitching.
- A double stitch density instead of the standard setting is essential for completely covering and encasing PUFFY during stitching. u Use satin stitches, not fill stitches. The wider the satin stitch, the stronger the 3D effect will be achieved! Step stitches will destroy the foam.
- A needle with SES point will perforate PUFFY
better than needles with sharp points.
Tip: A standard 75 needle usually produces good results. If the foam is visible despite correct digitization, select a 60 needle with SES tip or remove the foam particles with a hot air blower. - An extremely strong 3D effect can be achieved by using two layers of PUFFY on the base fabric. If needed, bond it with an adhesive spray.
Embroidering
with PUFFY is so easy.
It’s stitching as usual -
you only need to digitize the
desired embroidery design for foam
raised embroidery. You’ll find all
necessary information on this topic in
our tips on how to embroider
with PUFFY on our website www.shop.gunold.de
Accessories
